Комментарии:
The map sensor too
ОтветитьHmm my mazda 6 2.2d 2009 i tried this but this way did not stop the engine... Also i red that the engine can work if you remove the maf... So how should i think here?
Ответитьhello i have a question does my car hyundai accent 2011 has a MAF sensor or its just a MAP sensor?
ОтветитьShort and to the point.
ОтветитьSweet and simple thanks
ОтветитьHave a 2006 Passat. I do not have a check engine light or any codes, but I have noticed a drastic drop in my fuel economy. About a 5 to 7 MPG drop. I just did this procedure, and the engine stayed on. It shuddered some when I unplugged it, but it kept going. Ordered a new MAS. Lets see what that does.
ОтветитьThank you brother !
I really appreciate it.
HOLY BALLS IT WORKS.
MY CAR KEPT RUNNING AND IT RAN BETTER WITHOUT THE SENSOR. YOU ARE THE MAN!
2003 MITSUBISHI OUTLANDER
It's the simple things.....
ОтветитьNot on all cars some just run a little worse or better some times when unplugged
ОтветитьOMG you are so wrong on this subject that your information should be deleted like they do when you talk negatively about election fraud. BTW I just Un-Subed
ОтветитьMy 04 explorer starts but wont stay running when the MAF is connected but starts up and runs with it disconnected. But the acceleration is very low and really rough idle. Gonna replace the MAF and see what happens
ОтветитьThis is incorrect. This will only work on one or two cars. Do not listen to this guy, he knows nothing. The vehicle will revert to preset fuelling. The engine will not cut out.
ОтветитьIt’s not 100% proof. It works in most cases but isn’t absolute. Love the video though.
ОтветитьThank you
ОтветитьHow much does a dealership charge to replace on my 2016 mini cooper countryman mass air flow senser?
ОтветитьI have a 01 towncar, mine stays running when i unplug it, Im about to go ahead and buy a new one. I done spent alot of money changing out parts. Im really hoping this my problem
ОтветитьYour help is well appreciated thank you . 🇺🇲☝🇺🇲
ОтветитьSplendid good info and demo thanks 👍🏼👊🏼 from England 🏴
ОтветитьIf it’s going bad could I’d also affect the acceleration of the car??
ОтветитьIs this with any car? If you disconnect the MAF when running and it keeps running it good but if it stalls it’s bad?
ОтветитьIm not sure but i think if u disconnect in some car it keeps running because the car enter in a backup mode and uses old values
ОтветитьOne thing to add to this video is, if you're going to replace your MAF sensor DO NOT buy a cheap aftermarket item. They are a waste of money. Buy either the vehicle manufacturers own OR OEM quality.
ОтветитьHow about diesel engine
ОтветитьI know this is an old video but does it always throw a code if you need a new one
ОтветитьA no BS channel? Maybe a real Christian type? 🤔
ОтветитьThank you very much mate!!!!!!! But what happens if I don’t replace the sensor and keep using the car? Thank you !
ОтветитьWell yes and no you could also have an electrical problem bad ground, 5v to the sensor not working properly or no 12-volt power to the sensor or ground for the 5v power
ОтветитьI did it and the check engine light came on, can anyone explain plz
ОтветитьWat a bout I have a code po171
ОтветитьHave you tried to clean the sensor with that particular sensor cleaner spray before replacing the whole unit ? Or was it clear that it went broken ?
ОтветитьHave you tried to clean the sensor with that particular sensor cleaner spray before replacing the whole unit ?
ОтветитьSo my situation is weird… my car runs without it. If I plug it in, my car turns off 😂
ОтветитьSuperb ty
ОтветитьThanks for the tip having issues with something I can’t figure out , change fuel pump, fuel filter, p0171 comes on
Ответить6yrs later. 🙏🏾
ОтветитьThanks😊🇬🇧
ОтветитьThumbs up for a short to the point video
ОтветитьJust had one bad, there was lean bank 1 and bank 2. Found torn intake boot, thought that would fix. There was still a stumble when i mash the gas so replace the MAF and it was fixed.
ОтветитьTry cleaning them first with some mass air flow sensor cleaner made by CRC because these things are very sensitive to air flow across precise precious metal wires and can become clogged with dirt and grime from the air box also replace your engine air box filter folks while your at it
Ответитьsays on google it should still run
ОтветитьMay no weapon formed against you ever be allowed to prosper in the mighty name of Jesus Christ. Amen.
ОтветитьSuper Advice Sir. Super 😂
Ответить2008 Mustang GT - I disconnected the sensor, the engine surged a bit and kept running. Upon reconnecting the sensor the engine stalled. The fact of getting a reaction from the engine tells me that computer recognizes the sensor. I guess the sensor still could be bad. Scratching my head at this point. I’m torn between a bad TPS or a bad MAF
Ответитьcan you drive car with suchbimdication?
ОтветитьI have an 06 ford explorer that sputters when accelerating, started today, Im gonna try this today after work thank you
ОтветитьAwesome video, quick, informational, well done.
ОтветитьCan someone tell me where the MAF is located in Suzuki Jimnywide 1.3 G13B automatic vehicle 1998 model.
ОтветитьBrilliant
Ответить