Комментарии:
Just to be clear, I own a 2022 Hyundai Kona Preferred (SEL version for US...). Thanks!
ОтветитьIs there a step up from this bulb that is a little bit brighter? For the top lights the eyebrows is there a different light for them also?
ОтветитьGreat Vid thanks!!
ОтветитьNice
ОтветитьWhen I verify to make sure it fits on Amazon it says it doesn’t fit the 2022 kona. Does it for sure take 9005? And is this any 9005. I don’t know much about these
ОтветитьWilliam....first off..thanks for the upload. curious, you mentioned you have not had any warning lights or anything. Just curious if you have had any overheating issues? that seems to be an issue with some folks that switch out their lights for LED's. we have an SEL, and the headlights are pretty poor.
ОтветитьNo error codes?
ОтветитьHi, did you run into any ussues when installing the dust cover back on? I'm worried about purchasing an LED kit and having the heatsink interfere with the dust cover.
Also, how large is your heatsink? Thanks and great video!
Hi there have you had any over heating or flickering issues with these bulbs thanks bruce
ОтветитьMan this video is amazing thanks so much
ОтветитьMy Kona SEL is a 2018. is it pretty much the same for it also?
ОтветитьDoes this bulb in fact replace both low & high beam with a single bulb per side ?
ОтветитьJust want to say a big thank you for how to fit these.I used windforce 9500from a retailer here in australia and they look great.Just turn the wheel so it faces inwards
to give more hand room.
Hi
The LEDs are warming up to see if there were any problems ?
Regards Eric
What about tail lights? Are those able to be changed as well?
ОтветитьIs this both my high beams and low beams in one? Might be a dumb question. Just not sure if I would also have to buy another set to see better at night
ОтветитьWhen you install these make sure that the LED's point to the 3 o'clock and 9 o'clock position or they will not give you the best light. When I installed mine it took a few tries before I figured this out.
ОтветитьI asked the dealership to change all lights front and rear to brighter bulbs but they would not do it as it would make the warranty no use and would not cover the car for any defects in the future
ОтветитьThoughts on applying this upgrade to the 2019 Kona SE? I’m having trouble with the low lights in woodland areas at night
ОтветитьI'm not sure if I'll get these or a different one, but the last ones I put in also had great reviews and one just burned out. So tomorrow the stock bulbs are going back in, which sucks. The other thing that sucks is the light output for the Kona headlights. One bulb for low/hi is a really bad design. High beams don't actually give you more light, it just raises the light, so you get the same amount that was out front up higher, and what was higher is now what you see out front. I'm going to have to put a light bar on the front because it's just terrible at night. And no fog lights because more and ore manufacturers are saying fog isn't a thing any more, even though it is.
ОтветитьI just installed it now. No error codes but when installing it it didnt click trying really hard. So i just install it without it clicking in place. Will see later tonight how it goes.
ОтветитьDo you have to reaim them or anything?
ОтветитьI tried to install these on my wife's car. I could not get the car's harness plug to come past the hole. How did you get that much harness to come out?
ОтветитьWhat’s the trick to getting the little plug back into the small hole to lock the flap cover back into place. You make it look so easy and it almost impossible to get it back in. Thanks
ОтветитьI have a Kona electric 2023 with halogen. Does it work? Is it the same?
ОтветитьHow might this affect the warranty? Thx
ОтветитьHi....I have a 2019 Kona SEL and I am wondering if this will work for both the low beams and high beams. Thanks!`
ОтветитьI am just curious. How did high/low beam work with a 9005 which is a single "filament" (single circuit) bulb? Usually when I had car equipped with 9005 bulbs, they had 4x bulbs (4x 9005) where 2x were low and 2x were high. How did it work in the Kona, is there an actuator or something that retract for high beam?
ОтветитьHi I got an 2023 kona and H5 halogen so I don't if this is the type of led I need?
ОтветитьI'm quite surprised that they're still using halogen bulbs in these vehicles. These LED bulbs will only last for roughly 2 years if you're lucky. The price is low so you can purchase again & replace.
ОтветитьI have made the switch yesterday on my Kona EV 2023. The new LEDs (Ignite 9005) are so much better than the halogen. I just have one question regarding the presence of heat sink and anti-flicker modulator. The one I have installed had only passive heatsink (i.e., no fan) and no external modulator, like the one you have initially installed in your video (Nilight 9005). Did you or anyone else have issue with LED lights with passive heatsink overheating and for the absence of external anti-flickers module?
ОтветитьI just changed mine. Any idea size the plastic screws are that lock the panel into place? I would like to have a few extra since they were so difficult to remove.
Ответитьhurray, let's blind everyone with bright white LEDs
ОтветитьFinally! A well produced video with no extraneous crap and shaky video. Well done sir.
ОтветитьFrom where can i buy these lights
ОтветитьThe link is not opening
ОтветитьUPDATE: Four days ago I installed the Nilight 9005 hi/low bean (same one's in this video) on my 22 Kona N Line. I've had NO ISSUES and NO ERROR Codes... Lights look great and are much brighter and better than the Halogen. It took me maybe 15 mins to do both... Follow the instructions on this video and you won't have an issue... BTW, the halogen bulbs that come equipped in the Kona are 9005. You'll see this number on the bulbs that you remove...
Ответить