Комментарии:
I applied on my garage and is very week looking in some areas. Is that normal
ОтветитьBest Supporting video what I was looking for instructions for epoxy shield installation. Thank you so much.
ОтветитьWhat if it’s a brand new home?
ОтветитьSo what the hell do you do if you have 2 kits? I've been told to mix them because if you don't, you may end up in variations in color
ОтветитьLmao mixing with the wooden stick also B always goes in the A why the hell did they label the cans backwards on these kits. World may never know
ОтветитьI did my enclosed trailer floor. "Plywood" I put it on heavy. It's been 3 days now. And it's still damp to touch. How long will this take to fully dry? Yes I followed all the procedures on the directions. Is it because I applied it heavy??
ОтветитьI'm applying this to concrete without any sort of sealant or paint. Would a 3/8" nap roller cover be proper thickness for such an application? Since it's not a smooth finish and new concrete is the acid etch still necessary. Thank you.
ОтветитьHow well does this product hold up after time in a shop where cars are being worked on and used as a garage. i wanna do this before i move into my house and i dont want it to be flaking in a year or 2.
ОтветитьThe concrete floor in the garage of my new house is a little rough, it's not very smooth... Do I need to smooth the ground with a floor polisher before I use it?
ОтветитьI use the pant kit but it got hard on me quit I went out got another and it happen again what can I use to than it out
ОтветитьSo does this kit not come with a clear coat that holds the chips cuz over time the chips will chip off
Ответитьso I bought the epoxyshield 2.5 car garage kit and I really want to clear coat it but I can't seem to find the rustoleum Clear finish anywhere!. What other clear coat can I use other than the rustoleum brand that would be compatible for the epoxy shield?
ОтветитьCan I use rustoleum garage floor/concrete primer on cleaned and etched bare concrete prior to using the epoxyshield?
ОтветитьCan I pour the product directly onto the garage floor and roll it out from there?
ОтветитьThank you so much
ОтветитьNot what directions on box say
ОтветитьCan I apply this in a heated garage if the outside air temperature is lower than 13ºC? I'm moving into a new-to-me house in a couple of weeks, and would like to epoxy the floor before the move. The long-term forecast is suggesting lows around zero and highs not much higher. If I crank up the heat the day before and warm up the slab, will that be sufficient?
ОтветитьHi I was wondering if the flakes are decorative or if I could leave them out? I am not a huge fan of the specal look and want to know if they are absolutely necessary
ОтветитьHi,
The temperature here is 55-75 F and in the evenings/night time, it goes down to 40 F.
Is it ok to apply the epoxy during this time? Or should I wait for warmer days? I also also use two small space heaters if it helps. Please let me know.
BRING BACK A FREE AMERICA 🇺🇸VOTE JARED WILLIAM LANDRY FOR PRESIDENT 2024 AND CHANGE THE WORLD 🌎 DOING IT. It's time to put a real American in office.. I will stop all of it. Please share.
ОтветитьI have a new house and nothing has been on the garage floor as of yet. Do I still need to etch the floor? Also, the outside temperature is 30 degrees, but the garage has heat and is 75 degrees inside. Can I still apply the epoxy? Thanks
ОтветитьQuestion here
Can you reapply epoxy on top of already cured floor with paint chips , 1 day cured
We have some spots that didn’t go on thick enough.
Hola a quien me pueda ayudar yo aplique la pintura en un garaje y donde van la 4 llantas del carro se ve pelado será que puedo lavar nuevamente la mitad con el asido y aplicar nuev pintura sobre esa mil gracias
ОтветитьIdk about low odor. When you stir the fumes are intense
Ответитьi Have done several garage floors with this kit... never had any problems... preparation is the key... period.
ОтветитьThose chips that come in the pack taste awful. You should make them taste better. I thought it was nice to include a snack in the pack since this is a hard job, but boy they almost don’t even taste like food!
ОтветитьHello, I am plainng to DIY (epoxy) my garage concrete floor. After testing the floor with puring some water on it, I saw water stays and no soaking happened, does it mean it has a sealer on it? If so, I know etch can remove the existing sealer. My question is that if the package comes with 2 bags of etch, do I still need to use the primer? (because the etch is able to remove the existing sealer) I am a little confused, if I do need to use the primer, then the 2 bags of etch will not be needed? (Because the primer will be applied first.) Thanks!
ОтветитьHello am in Florida the temperature in the 90 to 100 degree do I have to wait in the the weather cool down to apply the product
ОтветитьHi, I have a 3 car garage, about 800sqft, what kit or kits should I get to guarantee that the color will match without different shades, also, planning to apply anti-skid and clear coat, any recommendations for this project?
ОтветитьTrash
ОтветитьHi, do I need 2 kits? Garage is 400sq ft freshly levelled with concrete self levelling material. I’d also like to add glitter flakes. Do I just mix it in with the 2 part epoxy? What clear will I need? Thank you kindly.
ОтветитьWorks great but do NOT apply in temps above the prescribed limit!
ОтветитьDo you have to etch new concrete?
ОтветитьI have a 2 car garage that ready to be painted. I want to paint 1/2 on one day and the other half the next. How does this work for mixing the product?
ОтветитьI’m confused. This video says to patch/repair any concrete prior to etching, but the patch/repair product box says to use it AFTER etching. What is correct, before or after etching?
ОтветитьCan it be used over painted surfaces
ОтветитьIf I am using the clear coat, should I add the anti slip additive to that, or the base coat?
ОтветитьWrong.. the instructions say etch before using the patch
ОтветитьTwo questions!
1.) For a more durable finish, can I purchase two kits in order to apply a second coat?
2.) If I want to then apply your clear coat over the two coats (flakes in the second coat) should I be adding the non-slip additive to the clear coat layer?
There is nothing anyplace about putting a second coat of
ОтветитьCan it be used in my cargo trailers plywood floor?
ОтветитьVery useful... especially the final product view.
ОтветитьDoes your garage floor have to be concrete? My garage is black top, haven’t seen any videos of it being used in black top.
ОтветитьCan I just use the Rustoleum that’s has prep and etch in one? Then grind if need be and then epoxy?
ОтветитьShould you add a primer first?
ОтветитьUmm..followed all instruction. Less than a month and already have tires mark and is peeling off 😫
ОтветитьCan I add glitter instead of the flakes chips provided?
ОтветитьCan you add Anti skid additive into Rocksolid floor coating mix? I am not going to put top clear coat.
ОтветитьCan I apply this to self leveling concrete and should i etch the self leveler too?
Ответить