Stalling issues fixed! Hemi 06 dodge 5.7 l

I been fighting a cylinder 4 misfire for a couple months. Going to try this.

its an old post but i have a 2006 300c dang thing is pulling p0700 u0100, I'm defiantly gonna check my connections this weekend same issue one day it runs and drives perfect next day itll stall 3 or 4 time then runs perfect hopefully its just a connection it seems to only do it when it rains or its wet out 😂

its an old post but i have a 2006 300c dang thing is pulling p0700 u0100, I'm defiantly gonna check my connections this weekend same issue one day it runs and drives perfect next day itll stall 3 or 4 time then runs perfect hopefully its just a connection 😂

Thank you for the video and advice. My problem also started after a big heavy rain and hail storm here in southern California. Luckily the problem started at home the following day. Replaced the O2 sensors and PCM. I'm at a lost. Did you also do the connectors to the O2 sensors?

Egr valve

Try installing new wiring harness

I'm having problems with the mds a code p1416

If your 5.7 is stalling on you you should definitely check the maf sensor

That makes more sense

always have this problem when it's hot outside then a cold front comes in with rain

What about when you have to put your foot all the down to started it I'll stay on but when put in gear it dies out

I just replaced my throttle body after chasing this stalling issue for months and now it's running great but I still need to replace my immobilizer. I also followed this video with cleaning and greasing all the plugs.

My 06 Charger RT will start most the time but the problem is the anti-theft system comes on so it stalls out and it keeps doing this and I can't find anything anywhere on how to disable the system or fix the problem! 😞

He's right.

What the grease call

How about keeping your engine bay clean .. my car did all this . Turn out to be the evac valve, nothing else .

Had a problem with my 05 dodge Ram hemi stalling about a year ago, took awhile to find the problem after trying tps senser, wires, excetra, with no fix. Then decided to check the crank angle sensor on bottom rear passenger side of block , pulled it out and the sensor end that goes in block was cracked, replaced and hasn't stalled in over a year now

I have an 07 ram 1500 5.7l. Anyone on here having trouble with the mds system? I replaced all 4 mds solenoids under the intake manifold. Still throwing the same code. P3497 cylinder deactivation system bank 2. Also did a fresh oil change as well. Cleared the code and it came back

Hey i got a 2006 dodge charger 212,000 miles and its having trouble starting any suggestions?

Everybody here got a magnum 💪🔥

I know this video is old but I know someone else is watching this at this moment , how do I clean the plug? With a tooth pick or something ?

I have an 06 300c and the car won't shift out of first stuck at 30 manual shifter not shifting it doesn't stall though any suggestions

I had problem with a hemi engine stalling at stop lights and what my problem was low transmission fluid

I wonder if thats the problem I'm having 🤔 06 charger rt I just got cammed but it did stall one time before the install, plus all my dash lights illuminated flickers sometimes

Hey I don’t have any codes or check engine light but im still stalling. Any help?

Yo chris go video bro ganna try to do what u did but do i put the pcm exactly how it was or did u say just lay it in there

One You Tube guy had his ECM replaced and found out that OEM computers are assembled poorly, using lousy solder, and just bad solder work. It could be that the pins in the computer side of the connectors aren’t connecting to the circuit board properly but sometimes when we disconnect and reconnect it happens to air just right, then at some point it becomes a bad connection again, and I’m sure heat and moisture don’t help. Maybe that’s why some guys have to go through a couple of computers till they find one that’s reliable. Apparently the place in Cary, NC totally refurbishes them and improved the quality of the connections. After massive experience and research here’s the only consistent thing I’ve seen. One time my brother(a one time Chrysler service writer) and I were talking about it and when I dropped my hood the engine shut off. Out of the next 5 times I did it, 4 times it shut off. So I hit the cowl with the heel of my hand with it running and it shut off. Then grabbed a rubber mallet, and if I struck sharply in just the right place it would shut off. But then after disconnecting the ECM and cleaning and die-electric grease and all it didn’t do it again for two months, then came back. I’m starting to think the ECM just needs to be rebuilt or replaced.

Why not just replace the whole wiring harness that’s what I’m doing I’m doing spark plugs,coils ,ecm and the wiring harnesses already did my motor mounts as well cause I’m having stalling issues hopefully that fixes the problem when my mechanic is done

I'm glad I live in the desert, no moisture

Where do you buy the throttle body cables at man I’m having the same thing literally baught everything you did now Idk what to do

I have a 2006 Dodge Charger with Hemi. Recently hit 100,000 miles.

I desperately need help my son-in-law change the PCM it's still stalling.

I got a 2006 Chrysler 300c I just ordered a pcm hasn’t came yet but my problem is the car shuts off just in rain rainy days but perfect in sun? Do you think pcm and what else?

I’m having the same problem right now, I replace coils, sparks plugs, EGR valve & did oil change and air filter change I’m getting P2303,p2305,p1128,p0300 what should I do?

Hey chris I have the same problem but it also goes into a mode where I can't go over 20 some times

Definitely true about the connectors. I got the famous service 4wd system message on the Jeep Commander I bought. I simply pulled the connector going to the transfer case motor, cleaned with electrical contact cleaner and added dielectric grease like you did. Cleared the code and it hasn't come back on. 4WD system works good. Good advice! 😉👍🏻

Did you replace PCM with or without codes??

Just got a 06 Dodge Charger 5.7L 290,000 ran good for like three months then all problem broke lose. I change the Egr Radiator Thermostat temp sensor Air intake Throttle body. I don't no what to do! Its ugly right now! What u think I should do? I was goin to do the PCM all coils and plugs next. Help Needed!!!

I got a 2006 Chrysler 300c it shuts off when it rains what could it be?

Thinking of buying one 165,000 miles on it.. looking for reviews and known issues

were you getting codes P0700 U0100?

I recently got my 2006 Chrysler 300c 5.7 hemi and it’s been driving great for the last past 4 days and then I decided to fill my tank up and then it started stalling out of nowhere and felt like it was about to die. Any help ?

Did you get stalling after a cold start up? Mine is saying it lost communication but nothing else. My mechanic can't seem to figure out the issue.

Replace the motor?

Hey my06 Dodge Ram 1500 5.7 v8 still stalls after I cleaned these wires and sprayed them