USB ADXLs for Klipper

dude i like your stuff but did i miss something? i have the Fstec accelerometer that i have used before on them ender 5 plus but i couldnt follow your video....

By the way, the Provok3d ADXL PCB absolutely is compatible with Revo hotends. Got one for mine and it fits perfectly. You can also see that in Nero3D's Voron V0.2 build series.

Have you considered running test prints on each of them to see which gives the best visual improvement?

I just stumbled across your vid! Even if the results are not valid the idea is solid! I have a usb input shaper wich I will compare to the ebb36 results now! The problem is to identify wich is valid, wich I would assume is wherever the device is nearer the center of gravity of the toolhead.

I am looking for an explanation on how to install the FYSETC. It seems that everyone else has been born with this knowledge as the minimalistic instructions I am finding all kinda say "Oh, well, you just do it like you normally would."

I got fysetc input shaper, holes pattern different from adxl345, I had to modeled a mount for volcano hotend by myself. And sorry for my English.

Alan, I tried the Fysetc board and was disappointed by it. Every time I wanted to use it, I had to re-flash the board and go through the "make" process again. Even though I was able to get resonances successfully, it wound up being more trouble than it was worth, so I sent it back to Amazon.

I just ordered one from you guys. Not sure which one I ordered lol

I just got input shaper working last night, had issues with "Timer too close" errors that were ultimately resolved by increasing the CAN bus speed from 500000 to 1000000. My set up is also the EBB36 and built in ADXL. Good to know there are alternatives out there, thanks!

Interesting comparison. I wonder if the USB cable has any influence on the results also.

Thanks for the review and installation instructions. Is hot tightening necessary to run the nozzle test? The user could always compare a test between hot and cold tightening.