How to test car ignition coil with multimeter.

I'm confused ... how are you getting a reading when the coil is on the ground and there is no electricity passing through the coil

Fast, simple, to the point. Thanks!

Just what the doctor ordered sir! For people with cars in the VAG group i heard this can be done with OBD Eleven as well, without having to take them out i suppose. Great video anyway! 👍

Okay so we use the first and last prong to test.

What ohm resistance do we use on our multimeter?

How do i know what is the perfect reading it show 23 but how can i know that is a good rate maybe it should be more

Wow! So Easy!

What setting on Ohms

Thanks for the helpful video. I have a Lexus V8, on the right head the coils have 27.5 and on the left head about 22. Can this cause misfires?

All those videos and your's is the one straight to the point. Short and useful. Thanks bro

.

very helpful

My Honda coils have three prongs. I don't know which prongs to test.

UK 3 mmmm2kk3k2l3lkkk3kke3kk know i3 >i i i3kiwoooeoio3

Thank you for this clear and simple explanation on how to check the coils!

So if mine for my 8 cylinder toyota tundra (4 wire) is reading OL, it's bad?

3.6k subs 81k views, good job. Thanks

Thank you,

thank you so much your video very helpful

Hallo first of all thank you for the clear video!
I have tested 4 coils:
25,8-25,8-25,8-27,4

Does this mean that the 27 is putting to much risictance and thats the one that giving me problems with the car??

Awesome. Very short and straight to the point. Well done

The best and simplest coil testing video, great job bro

Get a microphone...your voice is very low.

i have toyota auris 1.6 vvti dual and i check it. 1 and 2 show 26 ohm but 3 and 4 show 34 ohm why?

The video would be better if you explain that
1) out of the four pins, how to determine which two pins to use
2) your ohm meter has only one setting (Ohm). Most meters have 200, 2000, 20K, etc setttinggs. Which one to use

Thank you !!!!!!!!!!!!!

Are yours coil the 4 pin ones for Toyota ? My coils measured at 22k ohm, so do you think it's okay ?

Thank you thank you thank you!!!!

Dis dude is so helpful!

Thx u

Super helpful and straight to the point!

Excellent.. Thanking you

Great video thanks!

Thx

Thanks for the video… straight to the point!!!!

Thank you. Before anyone panic not getting reading, my coils gave resistance approximately 340 ohms, but wasn't showing because ohm range was 200. I set to 2000 and it showed ratings. Make sure to check if having problems!

Thank you very much for your video 🙏🏼. I saw many videos to test the coils and your was the best and help to figure out I had 2 bad coils. Thanks again and many blessing to you!

Coil denso ncp93

Thank you thank you 😃😃😃😃😃

Very informative thank you

Thank you! What is the at least above number reading and the possible too low number?

Perfect! Thank you!

Hii