TBS Source One V5 frame launch by TBS (credit to TeamBlackSheep)

why the hell no instructions about the build?

Problems on the arms, fully tight and it still moving, 3mm holes for vista! But realky sad about the arms, good idea 6mm but it is shaking holes to big? Or xthing on the middle not well messuared

Found 2 issues with the new V5 frame.
The 20 x 20 holes at the back are 3mm and not 2mm as vista only accepts 2mm bolts so useless really except using them to zip tie vista with some double sided.
The max width of camera with carbon side plates is 18.5mm so you cannot fit a 19 or 20mm DJI camera in it.
I got round this by sanding down the side plates 0.8mm each to get the width of a DJI camera.
30 or 20 stacks not a problem.
Room for a vifly 2 buzzer and the capacitor just behind the camera.
Change to 2mm holes at the back and thinner side plates and its a good frame for vista build.

“Everything else is more or less the same.” Too bad this doesn’t apply to stand-off spacing. Got ahead of myself and printed v4 parts. Any skinnier and this frame would be a pencil lol.

i need it now and some arms
better in europe shop

Maybe I'll run this when I have to buy a frame big enough to hold the fatshark hd stuff I preordered in god knows how many months from now.

The "black Cross" is over 800 years old 😅

It's supposed to keep arms from flexing, unfortunately you forgot to test that.
However. What's wrong with my nano RX, the TXLQ fluctuates a lot even at close range and flashing only works sometimes. Is it broken?

Where can I find the stl files for the v5 frame tpu parts