How to Create a MikroTik PtP Bridge Link

Hi Tim, how many km can the 60GHZ do? I am planning to try on a 3.5KM

How precise does the alignment need to be on a MikroTik nRAY 60GHz? I'm trying to establish a link at 710m, but the antennas aren't visible to each other (I have line of sight). I can adjust the direction easily, but the issue is the tilt because the antennas are mounted on poles and aren't easily accessible without removing them. Do you have any ideas on the best approach for this? Tnx

Thanks for the excellent video! Short and to the point, it really helped me out configuring a P2P bridge on two MikroTik devices.

Thank you, it was really helpful!
For some reason the nv2 password was not exported (or imported), so the link kept disconnecting until I manually entered it to the station-bridge.

What is the range and orientation of the devices?

Hi, I'm trying to setup the same type of bridge network using RB450s, however, there's some wireless settings you've change here that aren't present on RB450. May you please demonstrate how you'd accomplish this using the RB450? Thanks.

Should I be trusting the informatio from someone who can not even pronounce mikrotik (my-crow-tick) correctly, and no its not the S.A. pronunciation , and for those who dispute this, just watch Mikrotik's own videos.

Hello I have Mikrotik wap ac antena and I would like to connect this antena to wifi on my router and connect antena to my pc with cable, can you help me with settings. thank you

Hi. Sir. Timhow are you., I have a ptp using two ldf ac and after the ldf cpe i use a switch but very often the ethernet drop when it drop I have to reboot server router is give the ethernet I have all how you had said ., what do you think

Why one end has wireless mode to bridge while the other end has station bridge? In station bridge mode less wireless stats are available (Tx/Rx signal level only shown in bridge mode)

Please make a short video for PtMP NV2 protocol, with relevance to it's synchronization (I don't understand the wiki) and security.

Finally, a clear, concise and very useful guide. Thank you very much! Continue the tutorials! I clik subscribe and greets from the heart of Europe - Czech Republic.

Hi, weird question, but what's the brand model of that ethernet dock used on that Macbook? I've been struggling to find one exactly like that...

Hi Tim, I have a directional LHG LTE pointing to tower, feeds into my router. Challenge is I have 2 houses on the same premises, I have another 18dBi mikrotik CPE and a Ubiquity Powerbeam CPE... How can I bridge the mikrotik and ubiquity CPE's ? The distance between the houses is 70m with direct LOS.

Do not leave your wAP60 frequency to “auto” we had one work fine for two weeks then started bouncing hunting the best frequency

Please do a video with 60Ghz with 5Ghz back up radio. Thx!

...nice, nice, but...If you do not need an IP on the bridge, simply don't set it! But if you decide to set it, it definitely should not be in the same subnet as all the other traffic....

Hi, maybe You can help me i have LHGG-60AD, and the distance is 600m. Connection is really solid but i cant get more than 100mb/s. Where is problem, what should i check to get 300mb/s. Bandwitch test show me 950/950 🤔

One thing that is not added is the ip, should you apply a ip on the bridge for both and also should you add a ip on the station ether 1? (wap60)

Thank you for the reply . I have always used Ubiquity equipment and have come to rely heavily on their alignment tool. Can you maybe elaborate on how to align Mikrotik radios properly. Does it have the some form of alignment tool ?

Please share a video for point to multipoint also