Thanks DeWALT #shorts

Bruhhh don't use shit from another grinder and BS us!

Funny😂

I've never had to use a wrench, just locked it and grabbed wheel and turned. Always has worked. I better go get a wrench so I can get off now

Always read what it says on the disc for safety reasons

When did they change angle grinders disc locks. Given I have like a 20 year old dewalt from my grandpa , It's cool to see you don't have to buy those stupid keys anymore

Pouf ! ben faut retourner au magasin ! et demande le bonne outil !! voilà voilà

You can open it with the first key too. It's easy.

Ok but bro u can change it with ur hand

Useless video...

I feel like all these videos are just being made for Funkfpv now

The board is facing the wrong way, it should be on the other side

Makita

К ушм идут специальные ключи если что

на папиной нету

Откручиваю диск ударом руки и не парюсь, даже когда диск ломается.

Pas besoin d'une clef pour retirer un disque

Ну зачем ключ, она и так закручивается 🤔😎

Original key goes in two holes side by side, not holes across from each other.

Perdona la mia totale ignoranza sul campo,ma se il buco é tondo e quella ad esagono,come fa ad innestarsi da poter far forza sull asse del flex?

Fak

He had to make another video to show people he was in fact using the correct tool 😂 man does a great job dealing with the incels

Один зуб ключа в отверстие, а второй просто в гайку упереть.

Wait, these aren't disposable? I've been just throwing the whole grinder away after they stop cutting good.

Валянок !

You forgot the part where the Allen wrench strips the inside of the hole

வாய்ப்பில்ல ராஜா

There is an easier way then that with the last tool the last tool has 2 pins put one in the hole an the other outside the grinder nut then loosen because the other Allen tool will strip out the hole in the grinder nut

What is allen key size ?