DeWalt and Ryobi French Cleat Multi-Tool Holder

Happy New Year! Just as I was wondering what that empty holder on the left was — vroomp, lightsaber. 😅 I like how you marked and pre-drilled for all the little hangers — will have to remember that.

I have a multi-tool from Ryobi, Kobalt, and Hercules. Why? Because I am a man, and that is what we do!

Nice!!! Thank you for the content

Everyone needs a lightsaber in the shop.......

You're the tool holder master. Great video. You can always find your tool if it's hung on the wall. Mahalo for sharing, Sensei! : )

Thanks, I am always getting great ideas from your french cleat holders, thanks

😂 love it

A person has both Ryobi and dewalt tools because when they were a beginner and didn’t know any better they bought ryobi because it seemed like it could do the job and was a lot cheaper than dewalt or Milwaukee tools. Then when that person becomes more experienced and knowledgeable about power tools they later by dewalt or Milwaukee. That’s why a person has both ryobi and dewalt power tools.

very nice idea and lovely video, thank you for sharing

I would like to see the dimensions for the dremel cabinet

Well done sir... i will be doing this also.

I like the idea of using thinner back plates as opposed to every woodworker using the usual 3/4" boards, those always look like an overkill for the tools they're holding. Are you sure this thinner scraps holding your multitool by just glue is trustworthy though?

Love, love, love these French cleat holders for my multi-tools! Subscribe for more projects!