Kitchenaid Mixer Teardown and Repair - Trash to Treasure

You forgot to mention the pin on the output boss

Thanks, it was my brushes as well. I had no idea, i got it today, took it apart to clean, and put the brush back in wrong after cleaning.

I’ve got the beauty ring off my Artisan tilt head. But there not that much space to pry two screwdrivers in between and it’s just not wanting to budge. Is it possible my doesn’t detach? I don’t want to break it

Mine had the exact same problem! Thankyou!

Generally, no power at all, check your brushes. Power and no attachment movement, nylon worm gear needs to be changed. Mixer pulses or runs for a few seconds and then stops, change phase control board. Speed fluctuates or doesn't run at full speed, try to adjust speed control plate or replace it. You must calibrate speed control after removing the plate for any reason. Hope this helps someone.

The video skips a step. There is a pin that has to be punched out just before the double screwdriver is used to remove the mixer shaft.

I wish I was living closer to you just in I case I might need somebody to repair 2 of my KitchenAid Mixers. Nothing wrong with them but I’m saying just in case.

Hey, that mug looks familiar!!! You are a renaissance man!!!

Nice work. Time to make some cookies 🍪👍

That's a lot of grease! Now bake a pie.

Let's goo a new video

Release the shmu!
MMMM. Brush Meat - LOL