Комментарии:
Where does the connector that is connected to the air cut off valve run too? I have a mark 3 what would switch off when coming to stops, found my cut off valve was disconnected and the wire it was connected to ran through the fire wall, but I see here it runs somewhere else
ОтветитьI Forgot to connect the little earth to the tappet cover 😂🙄
ОтветитьFaulty vacuum advance will also affect the ideling
ОтветитьMy car does not drive properly only when I pull the joke out fully out any tips
ОтветитьHow to install mk3 choke
ОтветитьMy golf mk1 is blowing oil on deep stick, what is the problem
ОтветитьMk1golf idle but not rev up man
Ответитьfor idiots
ОтветитьHi PJ where are you sited, need your help on my Golf
Ответитьmay I please be in contact with you. I've got a golf 1.4i that's got a rev/idle issue. When it turn it on the revs go up to 1200pm without any acceleration. When I drive it and I press down the clutch the car revs itself. I've changed the map sensor as well as clean throttle body with carb cleaner and the problem still is persistent
ОтветитьRevs go up and down
ОтветитьMy polo classic is converted to a curbarator and the idle cut off valve is not connected and i don't know were to connect it please help
ОтветитьThank you your channel has done wonders for me as a MK1 driver.
I just wanted to as if you can WhatsApp me a picture of the fuse box diagram for the old spec golf similar to the one you have.
Hello sir. I'm at my wits end. My car intermittently stops idling. I have cleaned the carb. Put on a new flange and replaced the earth wire. Strangely enough this happens when I hit a bump too.
ОтветитьWhere u based mr
ОтветитьWhat years were curb and what year did they come out with fuel injection?
ОтветитьGreat stuff 👍
ОтветитьOn my golf that power supply Cable for idle cut off valve is not connected just only one cable. It's half
ОтветитьMy mk1 start but cut off when I rev what might be the problem?
ОтветитьMy Citi Golf with Carb doesn’t idle as well, I found the Cut off valve cable naked, it must’ve been in contact with the chassis resulting in short circuit. Now I need to replace the cut off valve
Ответить2002 mk1 fuel injection cold start idling in the morning when warm start first time only when cold it don't want to idle have to keep om ref to warm then it idles. What do you think?
Ответить1.5Golf Mk1 waterinlet on head what does it look like
ОтветитьHow to change phost
ОтветитьYou have good style and good speaking style for those who do not English language good
ОтветитьMy golf mk1 cuts off when the rev count is below 10rpm I even replaced the cut off valve still the same problem applies, even when driving sometimes it just cuts off and there is no idling when is cold only when the car gets warm
ОтветитьWhere are you guys based at? I really need your help
ОтветитьYou are so right. The carb service kits and base plate gaskets we are getting in RSA are rubbish.
I am getting some victor reinz gasket today.
The service kit I bought 6 months ago and the diaphragms have perished. 😢
Hi Mr PJ why when I press my accelerator my car cuts off I drive a golf which is a 1.3 carb
ОтветитьHello please help me my golf 1 is not idling I checked the idle wire it's working 100z
ОтветитьThanks for your videos, really appreciate it. I had a torn base plate, bought a new on Victor Ryens Sealer. But I still have the care cut out when I do a sharp turn to the left. (like a u-turn) Bought a new fuel pump just to find it was worse real erratic idling, cheched no fuel. So we installed the original fuel pump again and it is better. The fuel separator I blew out with a compressor, but maybe I must change it and the fuel pump. Checked the distributor vacuum advanced as per your video (the pipe was perished at the back of the carburettor. Cut it and refitted. Car is better but still 1000 rev ruffness when idling. And pull away jerky .
ОтветитьHi, thanks for all these video's, they help a lot. I have a vw baja with a twirnport engine but they fitted a Golf carb. When I start her in the morning she idle's perfectly. If I leave she goes fine until it seems the engine heats up or I go uphill she hesitates and eventually I cant go further. Do you have any advice, what can cause this? I've checked vacuum leaks, fuel lines, I must me missing something. Thanks.
ОтветитьHow do u change the idling jet
ОтветитьThanks broe"
ОтветитьHello what causes the car to over fuel and pre ignition.
ОтветитьIf only I knew where you stay
Ответитьgood mornig PJ. plead3 can you help me. I have a 1.3 Citi sonic carb. it starts but does not want to idle please need your advice as I am very close to put a match in the car 😂
ОтветитьMine doesn't have the electric idle valve or servo boosters haha
It's probbably just a clogged carb..
How do I bypass the map sensor on my mk1 carburettor engine
ОтветитьHow to fix rough idling after changing plugs
ОтветитьCan u maybe tell me for fuel injection why it dont want to idle
ОтветитьPls make a video regarding the control box for the carburetor vw. The box underneath the steering wheel. I think its found in the new spec dashboard. Controls the dashboard and indicators or so. Just to explain it in more detail.
ОтветитьThank you so much sir. Ur help is really appreciate.
ОтветитьQuestion, now what about fuel injection? if I start my car it idles, when I reserve out my driveway and take my foot off the accelerator it dies. when I come to stop and take my off the accelerator to gear down, it switches off.
ОтветитьSuch a great channel 👏
ОтветитьCan you please send me your address I want to bring my mk1
Ответитьi have a dead cylinder car idling on 3 cylinders only what do i do?
ОтветитьHi I was wondering if you can help me..
My car start perfectly but as soo as leav the throtel it just switches off
There is nooo ideling at all have to drive with my choke on...
Any help please?
Please help
ОтветитьSir my Golf just cuts when I drive
Ответить