Комментарии:
I've been bowling for nearly 10 years and I still can't get it right...I have ADHD and have troubles focusing on my ball control.
ОтветитьThanks for the great tip. This has been my focus this league season, and my scores are up compared to last season.
ОтветитьAfter replaying 1st shot and comparing last shot. I noticed a few things different . 1st shot, slide foot was on board 20 at fowl line, ball was at 12 board at arrows, and about 7 board down lane. 2nd shot. slide foot was at 22 at fowl line, ball was at 14 at arrows, and about 8 or 9 down lane. Hand release looked the same on both shots, so no change in hand position. just slight move to left was the only change I saw that gave the ball to his high flush in the pocket . When leaving flat 10's, my move is to backup couple of inches on my start on approach which gives a little more speed to execute a better shot. Good video as usual . Good luck and good bowling.
ОтветитьIt would be helpful if you used a ball that had a different color scheme so we could actually see the rotation of the ball down lane. Even at .25 speed I can't see the rotation.
ОтветитьMy son and I love going to Mike Shady clinics. We've met Mike Machuga twice at NCAA regionals.
ОтветитьLots of good advice on this channel.
ОтветитьAs well as tucking your elbow inside( zero chicken wing ) as much as possible during your downswing and watching the ball motion down lane ( once in a while my wrist will collapse at the release point and the ball will be a spinner which means there will be very little deflection, and probably end up with some nasty splits etc………)
ОтветитьI throw a backup ball and can’t seem to stay consistent. I also miss the 7 pin almost every single time I leave it.
ОтветитьWhat I recommend in the future is to have a more slower motion of the ball releases so we can see the differences. The slow motions of the videos was not slow enough to get a better understanding of the ball releases.
I thought that you have to increase your index finger for the ball to create shape? That is what I had been doing to knock out the ten pin.