New Method to Setup Raspberry Pi 4 64-Bit (Headless, Remote Desktop, or Peripheral Devices)

Make more ,Iam a noob and my screen flashes blue a bunch but loads up .its a 4 in miuzei touch won’t wok ,system is twisteros?? On repi 4b

I have been building a custom 24 x 36 printer. I have ran into a snag I could use some help with. I loaded ocroprint on my raspberry 4 just fine. I installed the plug in for octoklipper and it went fine. I went threw all the steps of getting kipper clone and running makeconfig. It all went fine. I created the firmware.bin file and flashed it to the Octopus Max ez and it chander the name to firmware.cur so I pretty sure it went fine. But her is my issue. From this point the pi and octoprint can not see the board. When I run the ls command to find the address it says there is nothing found. When I try and open the configuration file in Octopus to edit it says file does not exist...

What am I missing or what do I need to do different?

HELLLLLPPPPPPP

Hey dude, thanks for the great content!
Does VNC work (or can be set) via internet like TeamViewer, or only in local network?
Thanks! :-)

Amazing video😍😍😍.
It's so simple , i have done the whole process in single short .
Thanks you🎉🎉🎉

question: My SSID has no password and I don't wand to add one
Imager seams to require an input Dilemma How can I enter no password? thanks

Thank you for the help. Keep up the good work!

What's the ram size of this raspberry pi 4 module B ?

Thanks for the video! I haven't had a usable monitor and keyboard in ages. Also, I may have missed it but I didn't see where you updated and upgraded the operating system. If anyone would care to do so, it's: sudo apt update && sudo apt full-upgrade -y

Nice summary video, and I'm going to check out your license plate video as I'm interested in tensor flow lite. On a slightly picky not, during your installation of the R-Pi operating system you neglected to tell the user to click write while using the installer. Pretty obvious, but might confuse some.

Awesome video, headless was far less hassle getting set up (I dont have wired keyboards and micro HDMI cables)

I just use the RPI imager to burn the image on a USB SSD and connect it to the Pi and go. I never use the SD card. I don't know why nobody does it this way.