Aircraft Design Workshop: Fundamentals of Aircraft Aerodynamics

So were not going to talk about this so later on plus you'll understand so what we will talk about in a second so I'm otta hear.

I have no idea what I am watching. It's great.

You don’t hear that everyday!

Thanks

Why are we talking about 20 degrees AoA? This is beyond the critical AoA of almost all airfoils.

can you calculate coeffcient of lift on simscale?

will you still answer questions?

UAV inbound

I have create SkyHunter uav like your , but not stable without autopilot FyA41 😢😢

Its so sad, is Physics cheat us?

Nice

The authors have two wrong scientific approaches: researching the creation of Lift force and Low pressure at upper side of the wing, relative to the ground surface and Earth. I explain the aerodynamic cavitation and existence of Lee side aerocavern, and creation of Aerodynamic force.

Hi if we send you our airplane design can you can you made all nessesares calculation and reports?

how open the result report from simulation with simscale?

This was so irritating I had to quit. The plan for the presentation was fine. Unfortunately, the presenter talked about capabilities he wasn't demonstrating at a pace that was unintelligible. He started with a completely meshed model, the creation of which was a major purpose for the video. You may have more patience than I, but I'd recommend a pass on this one.

Its 12:15 am and I've decided to design and create my own jet fighter wish me luck boys

Where i can see the lift result 🙂?

Great channel

Thanks a lot, great job. :)

Hello My kid in high school is drafting a project on the effects of winglets on vorticity. Which simulator is simple enough to show the vortex by changing the parameters of the winglet without being an engineer? thank you for your reply

is the air a type of navier stokes fluid?

Great tutorial... Thanks for sharing!

sir can u tell me that what kinda maths is being used in aircraft design

Thank you for the great workshop!

Your workshop is called "Aircraft Design Workshop" however you show nothing else than how to run a 3D-CFD-simulation. To me designing something is about creating geometry models based on physics, empirical correlations, or whatever.

thanks we need more such videos

Is your mother tongue English???
I just wonder hhh

Mine is different I don't have the meshes thing

Our club AEROVJTI from VJTI College was 7th in AIAA competition in 2017 and 1st in design report

Its a Pioneer!

90 % had nothing to do with using this software silly

how do i get the steamlines shown with the newer version on simscale? i just can slice my simulation and show vectors on that cuttingplane. ????

если ты поц, ансис тебе не поможет . Профиль крыла был разработан еще при Гитлере , низкорейнольдсные две хвостовые балки , квадратный фюзеляж . И спрашивается нахуя тебе ансис если знания в этой области ограничены и нет никакого опыта ? Неандерталец с компьютером и все твои расчеты без мультифизики только яркие бумажки ничего не посчитавшие .

The aerodynamics would be simple and almost perfect if the aircraft had a push and pull two engine tandem configuration. The wings should be as close to a delta shape as possible. And the design could be the absolute best.

Can you use ANSYS and show the detail of the maths?

Thanks for made great video! It's useful

Sharing knowledge is great wise,tnxs alot

Fantastic video! Thank you very much! Could you let us know your e-mail and where can we find the presentation you have used in the video?

I loved the theory that backed up the whole simulation of creating mesh. Thanks. That was quite useful.