How To Fix a Brushcutter Trimmer Head Gearbox on a Honda UMK

How To Fix a Brushcutter Trimmer Head Gearbox on a Honda UMK

tinkerbod

2 года назад

7,307 Просмотров

Ссылки и html тэги не поддерживаются


Комментарии:

@niallsommerville9941
@niallsommerville9941 - 15.12.2022 02:36

Simple, waffle free, to the point and clear, well done and thank you. CV grease is my go to for anything non specific, particularly on motorcycles, I wonder if any of the big suppliers like SimplyBearings might stock the seal and seal spool.

Ответить
@xDrDeath78x
@xDrDeath78x - 15.12.2022 18:53

The annoyance in your voice is epic broski

Ответить
@gwendoline4116
@gwendoline4116 - 18.06.2023 14:40

Thank you so much! Have you a webside to buy the pieces please ? Gwen from France ! 🙂

Ответить
@stevekillick3905
@stevekillick3905 - 07.04.2024 13:03

Great Video, Thanks. Could you confirm if the bearings you specified were for the Honda 435 UMK or 425 UMK?

Ответить
@hectorlamar806
@hectorlamar806 - 16.04.2024 04:12

Would have been helpful to show how exactly you pulled it apart.

Ответить
@MartinLascelles
@MartinLascelles - 15.05.2024 15:23

Where did you buy the gears from??

Ответить
@MartinLascelles
@MartinLascelles - 15.05.2024 15:24

Does not tell us where to buy the bevel gears. I’ve searched high and low and cannot find six tooth splined bevel gears anywhere!!!!

Ответить
@MartinLascelles
@MartinLascelles - 15.05.2024 15:25

What is the use of pulling it apart if you can’t find where to buy the gears from??

Ответить
@justinf1343
@justinf1343 - 04.09.2024 18:31

Thanks for sharing this. I’ve just took the gear box head off my brush cutter and the shaft seems stuck in there as well. I was under the impression that the shafts just pushed into the gearbox assembly?

Ответить
@PeterNugam
@PeterNugam - 13.02.2025 06:33

I have a problem with gear being engaged fully when I start the brush cutter. Usually it doesn't spin until you press the throttle. Where is the problem

Ответить
@mattibeag1385
@mattibeag1385 - 30.03.2025 14:12

Thanks for the great turorial! I have a stuck greasing bolt on the same type of head: how could I get it out without damage?

Ответить