Комментарии:
Fucking under cover cop cars
ОтветитьDealerships are usually pretty good, but like any shop it's really luck of the draw with who is looking at your vehicle. If I don't know the issue the first thing I'll do is check for TSBs.
ОтветитьGood investigation. Unfortunately most Shops make money on parts so they like firing the Parts Cannot at it. Only when they still can't fixit, they may seek a Diagnostic Technician .
ОтветитьThank you very much for the video!
One addition I would make is, rather than resealing the Shark fin Antenna, it is better to replace it. The antenna that the vehicle comes with has water drain opening (it actually doesn’t drain but draws in water) at the back which traps water in the antenna. The newer ones come with the water drain hole in the front which is at a lower level so helps in draining off water if anything enters
Thanks for coaching me
ОтветитьWell that didn't help me fix my problem at all.
Ответитьhave problems with my 2006 Nissan Murano, Changed Pedal, Changed Trottle body and still car won't accelerate. Once changed car drives for a while gets heated and it goes to limp mode with Slip light and VDC displaying a check engine light, please any suggestions for possible solutions?
ОтветитьWhat about a Buick Enclave 2013 with a shutter that I’ve already replaced the pedal, throttle body, plugs and coils? Has popped p2138 once.
ОтветитьOh no! I have a code P2138 on my Nissan and now I remember I got water intrusion 2 years ago because my sunroof drain was cloggued! I also have other intermittent issues like the keyless entry is not working on the side where there was water intrusion.
ОтветитьAny chance this can cause engine stalls?
ОтветитьThis code just happened on my 2019 chevy blazer.
ОтветитьThank you very much! i have one right now that only sets the code when it rains. i will inspect for this problem.
ОтветитьSo the fix is to seal antenna and let the car dry out?
ОтветитьI HAVE BEEN DOING ELECRICAL ON VEHICLES FOR 40 YEARS AND TO DATE I DONT UNDERSTAND WHY PEOPLE PUT THE ELECTROLITIC GREASE ALL OVER THE PINS OR HARNESS,,,YOU ONLY CREATING INSULATION,,,,YOU PUT IT AROUND THE PLUG FITTING TO PREVENT WATER OR MOISTURE FROM GETTIN IN THERE,,YOU DONT PUT IT ON THE ACTUAL PHYSICAL CONNECTING PARTS OF THE CONNECTORS,,,,TNX FOR VIDEO VERY INFORMATIVE,,,
ОтветитьDoes the SB applies to 2012-2013 Buick LaCrosse?
ОтветитьSO what was the ultimate fix? Did resealing the antenna stop the problem?
Ответить