How To Install: MetalCloak JL Wrangler & JT Gladiator Baller Joints

How To Install: MetalCloak JL Wrangler & JT Gladiator Baller Joints

MetalCloak

11 месяцев назад

2,371 Просмотров

Ссылки и html тэги не поддерживаются


Комментарии:

@willrouse2351
@willrouse2351 - 23.12.2023 08:31

Yes!

Ответить
@santacruzoverlander
@santacruzoverlander - 23.12.2023 20:17

Video instructions are the best.

Ответить
@roncua6900
@roncua6900 - 25.12.2023 07:20

Now I’m 100 confident I can install

Ответить
@unSStoppable
@unSStoppable - 26.01.2024 15:17

Do these fit with RCVs?

Ответить
@JeepTJ1999
@JeepTJ1999 - 01.03.2024 07:42

Y'all know what y'all forgot with this instruction video? I just completed this task of changing out my ball joints in my JT & I got lucky that I didn't tear something up. For the rest reading the comments before or after watching this video, this is very important to do if you're changing your ball joints....

#1 Open your front differential fluid valve & drain your differential oil
#2 Loosen your F.A.D. that is located in the rear area of the your front axle. It was easier when I had this on jack stands & could get under the vehicle easier. Carefully take FAD motor off & slide out "fork-like" control that connects/disconnects your Front Axle Disconnect & pull out spline-piece.
#3 Now you may carefully pull out axle-shafts

Ответить
@odysseyusa
@odysseyusa - 06.06.2024 20:27

The last time I replaced ball joints on a vehicle, they were riveted and I had to drill them out and bolt some in so I just want to be careful. Will any ball joint installer tool work great or do you have a recommendation on a part number or characteristic? Thanks

Ответить