Комментарии:
God send absolute god send , only for this video the hubby would be dead lol ... Thank you very much for this video
ОтветитьThank you so much for this instructional, I just finished installing the shower now. No way I would have figured it out by myself. Thanks!
ОтветитьThank you. Very helpful.
ОтветитьExcellent video, slow and detailed makes retro fit of these excellent showers easy to install, thank you.
ОтветитьGreat video, just replaced shower in bathroom, thanks to this video for the last part of the procedure. Very helpful.
Ответитьgreat video but I think basic commissioning instructions should be included with the shower unit , I just purchased and fitted one and there was no commissioning instructions.
ОтветитьMy new triton goes cold about 3 minutes into my shower.what could the problem be
ОтветитьQuick question I followed all above steps , blue light coming on to show power is going to the unit but nothing is happening , what could this be?
ОтветитьBrilliant video, very easy to replace an old T90. All the screw holes lined up perfectly, no need to drill new holes into the tiles. Absolutely perfect. Thanks for the video.
Ответитьwhy we can't connect the triton shower to main water supply?
ОтветитьBrilliant..,explanation…👍👍
ОтветитьWe fitted one today and the pressure is hopeless compared to the older one.
ОтветитьBrilliant video, well done and Thank you.
ОтветитьVery helpful but would be better if narrated. Thanks
ОтветитьStep by step perfection
ОтветитьGreat video, just finished my install and this guide made it easy
ОтветитьGreat 👍
ОтветитьWhat I've learned during the shower installation (I am not a plumber nor an electrician):
1. Isolating the water supply (the gate valve which connects tank in the attick and the shower was located at the tanks bottom in the attick). I also turned off water mains from underneath the kitchen sink.
2. Isolating electricity: switchwd off the shower switch at the fuse board downstairs and also switched off another switch just outside the bathroom. You could also switch off main electricity switch at the fuse board.
3. When removing the old shower, be careful not to allow remaining water in the pipe to get into an inside of the wall, it might leak out somewhere downstairs)
3. Previous showers (T90si) wall fix holes were not at the same place as this showers. I needed a drill for tiles to make the new fix holes.
After these steps, the video does the tremendous job in guiding you along. The shower itself is great. Hope someone will find this useful.
We just used this tutorial to fit our new triton shower. Thank you for this tutorial. Its clearer than the instructions that come with it. Only for it we would be still scratching our heads. Really clear and easy to follow and a great shower.!
Ответить