Arduino UNO CNC Z AXIS PROBE With GRBL Comand G38.2 on Universal G Code Sender (UGS) Easy Setup

Any video for autoleveling of ugs?

prefect thank you 😉

thank :)

Hi, tried to install same way same probe on same adruino. mill goes down till it touches platform and stops. Writes PRB:.., but do not write "ok". after that it doesn't take any command and after some time writes: "ALARM: Probe fail". What reason can there be for that ?. I need to hard reset it or push "close/reset" like 20 times or so.

Hello, very useful video. What I want to ask you is how can I decrease the return to Zero button's descent rate to the zero position. Trying to land too fast so sometimes he skips teeth

I subscribed because you put all the needed info in the description text. BAM. I got what I need. Thanks.

how and where can I record a macro to zero the probe and then go up 5 millimeters? my probe is 19 mm high

Penyebab sumbu z bergerak sendiri apanya yang rusak. Saya pakai arduino uno, dan tb 6560. Mohon pencerahan. Terima kasih

Is it the same pin with arduino mega 2560?

very useful lesion dear, i have never word in thanks meaning +whatup +094778844088

Grate, tks

Muito bom

Thank you!! I was looking for this thing for months!!

when i was searching for information on how to install a probe for arduino uno, i couldn't find any easy to understand tutorials. hope this will help someone :)