Комментарии:
Magic!
ОтветитьThank you for your videos. You are helping me get ready to tackle all the scratches on my car's paint!
ОтветитьLove your video. Will this method work on Mercedes pearl white? Thanks in advance.
ОтветитьMany thanks for your valuable experience but I would like to ask can I add a clear coat + hardener ratio 2:1 with metallic paints for deep scratches repair or even light scratches
ОтветитьWhy do all these amateur video makers have to wave their hands constantly in front of the camera?
ОтветитьHow much was kit
ОтветитьHOLY COW! I have to rename you "Merlin". Even with 20/20 vision the repaired scratch cannot be seen. SUPER JOB! Thanks for sharing.
ОтветитьCan you use touch up paint from the dealer that is a match of the original in the same way?
ОтветитьThanks for teaching us😊 :)
ОтветитьNice to see this done on a metallic coloured car and not a flat white car. Great job!
ОтветитьAnother great video, got a pure silver R56 mini i will be having a go at scratch repair etc, will watch and rewatch these, as they are very helpful thanks!!!
ОтветитьCould have filled the rest of it with UV clear and sand and polish. Otherwise great repair.
ОтветитьExcellent job! Just subscribed.
ОтветитьThanks - that's a great job.
ОтветитьI appreciated your throroughness throughout this DIY; especially, like how you pointed out users' expectations. The quite amazing results surpass the ease, low cost and speediness of the process. Thanks for sharing.
ОтветитьVery therapeutic to watch
ОтветитьEarned a sub from me, great repair videos!
ОтветитьI LIKE YOU❤
Straight to the point. No f-ing intro.
Nice cool way of talking. No screaming American here😅
...AND I AM LEARNING🧐
GREAT STUFF🫡
That's a pretty decent fix. Is this the correct method for a long key scratch the length of the vehicle? It's a pearlescent red paint that is normally a metallic base coat with a coloured lacquer over the top. Again, it's very deep, having cut into the plastic on the bumper and removed some primer in places on the wing.
Would love to know if I could attack that myself rather than facing £1000s to respray the length of the vehicle.
Also if you'd have layered up the paint on the scratch more would that have caused issues when flatting down or could that have potentially removed the depth of the scratch altogether?
Are those products available in UNITED STATES?
ОтветитьJust started following ur channel. Amazing content. What did you use as paint and primer
ОтветитьIf your eye doesn't immediately catch it its all good in my book. Great fix.
ОтветитьWow! Great job, gives me the confidence to have a go at a big scratch on my drivers door ....thank you 👏
ОтветитьThat’s amazing - thank you for putting these videos together for us. Wish I could get your products in the US.
ОтветитьWas the base coat not prepared in the bottle already ?
ОтветитьIt's certainly not an eye sore like it was. Nice work.
ОтветитьNice job!
ОтветитьGreat informative video, What paint do you use to rub into the chips before flatting ?
ОтветитьThat’s not a deep scratch! When you see the primer, then it’s deep!
ОтветитьGreat job 👍 That's how I do it as well.
ОтветитьVery good. Also, people should always be aware that a repair, is barely visible, from even a short distance away. Not unlike viewing a wall-mounted picture/photo, if you like. Imperfections are there to be found, in all walks of life, if you push your nose against it? And how often does anyone do that?
ОтветитьSorry for asking but what is “laquer”can’t find the right translation in Swedish. Is it the same as clear coat? Nice job btw
ОтветитьWould you say this is the better way out of your blob on smooth out with spreader. In that one you dont mix the gloss the same. This one looks easier.
ОтветитьGreat video and easy step by step thanks
ОтветитьCan you please tell me which compound and finishing polish you used?
ОтветитьOnce the polish and wax wear off will you notice any blemishes caused by all the abrasives used?
ОтветитьYou would honestly be better buzzing the entire hood with a da sander and 1000 grit,foam tape up to the swedge line next to the scratch and blow it in properly with a spray gun and re-clear the whole bonnet in about 20 minutes and a proper job..
ОтветитьI tried and csn not get hazzy effect out panel with polish and compound
Ответить"If you catch it at the wrong angle you can still see it." I had to raise the resolution to 720p and still squint to see where it was. Awesome vid. Glad I found this channel today. 😅
Ответитьwatched about 5 of these now this is the best one
Ответитьso clear coat not required?
ОтветитьEvery deep scratch has to be painted . Otherwise it is bullshit work. Everybody can see where the scratch was ☝️☝️☝️exept you wanna sell your car …. The new owner can be cheeted 😂🤣🤟🏽
ОтветитьNeed to paint my bonnet, where's best place to get colour match, about a litre I need
ОтветитьGreat job mate! I was interested to hear your comment re Solvent paint vs Water based Acrylic paint. I have bought water based paint and clear to spray my spoiler and rear bumper that has deep scratches. You mentioned that water based paints wouldn't work, was that just with this system? Thanks
Ответить👏🏾👏🏾👏🏾👏🏾
ОтветитьFascinating images of the back of your hand 🙁
ОтветитьCan you use T cut black paint restorer as a compound to polish at the end.
ОтветитьWhen will the first AI nanos be introduced as these will just re-generate
Ответить