Milling out for a PDQ

Very nice! Very nice when we see young ladies (or older) have their own AR's, a refreshing thing to see. I really want to get one of this for a future project I have planned, the PDQ. You can thank Ebomey for spreading the word about you guys!

I just send out my stripped lower and you can mill and install my PDQ?

I'm getting ready to do mine. I was wondering if I can just use a drill press and go up and down to cut mine. I have a carbide end mill 5/32 × 3/16 3F SE 40°TiCN, is that wat u used or will that b good to use? And wat size file did u use. I mean how thick was it? Or did u not need to use one. Thanks for yur help

Do you sell the drill bit/cutter for the mill? I have a mill but don't have a drill tip/cutter.

OK, using a plastic straw to hold the bolt release assembly in place while installing the pin is genius.

I did that using cheap mail.Cost me two hundred bucks slower rate but still good results