How to Fix a Soft Floor in an RV using Epoxy Injection

Question, does the epoxy cause damage to the foam under the top panel ? I need to do this but was worried it will cause damage to the middle foam layer.

How much does this cost if a repair guy does it.

I am concerned about the exothermic reaction of epoxy igniting the styrofoam anyone have any issues with this

Our soft floor is in hallway outside of the restroom

Oops, I forgot to ask. I have seen a video of someone using that spray foam insulation. Any thoughts regard using that?

I am 74 years old and am about to tackle your method. How long from start to finish should I expect to take?

Is there any other way to fix soft spots I have a 2020 travel and it’s got a couple soft spots I don’t want to remove the vinyl flooring

Is there any other way to fix soft spots I have a 2020 travel and it’s got a couple soft spots I don’t want to remove the vinyl flooring

Is there any other way to fix soft spots I have a 2020 travel and it’s got a couple soft spots I don’t want to remove the vinyl flooring

What are the materials you used

Hey here an idea why don’t there quit building crap for rvs, everyone sick of going back and fixing there cheap mistakes

Awesome video. Looks like you're answering comments so ill ask: If we dont have a laminated floor but heavy non water sag, could you drill threw the floor into the foam, epoxy, then put home depot laminated flooring ontop?would you change anything? Thanks!

This worked like a charm, floor is very solid where I did the epoxy injection. just a word of advice, if you are planning to order just a gallon, better buy 2 gallons and a good orbital sander...

Has anyone else actually used this method?? Sounds great but just wondering if anyone has a success story?

How deep did you drill the 1/2 “ holes?

That floor wont be even using this method.

What does this do to the insulating value? Any decrease?

What kind of glue did you use? I’m starting a project like this right now actually lol

Where do buy epoxy

Why don't you use linoleum glue that is spread with a trowel that floor installers use in homes. On the other side, you are lucky the original floor was not glued.

If I am not mistaken, you put back the original linoleum that you have cut at the beginning.

We put tongue and groove flooring in our RV can I want to epoxy over the top of it. What do you recommend??

can you list the epoxy materials used?

This is what I think is going on with our 2021 Keystone Outback. Can you tell me what kind of epoxy you used. Thank you so much for sharing this video.

Awesome video!

Been looking for a solution to fix my sagging floors (not water rot, just the styrofoam is compressed) and this is a lot better then taking the whole floor out and putting in bracing. Only thing is with my floors, they have sagged down between 1/4” to 3/8”. Do you think the epoxy will lift that back up enough to make them level again? TIA

Do you know what type of floor is on a 2007 Springdale Summerland?

great knowledge and tips and a video

where are you?

I've seen dowels used with the epoxy. Are they necessary? Thanks!

Thanks for the demo! How deeply did you drill?