SQUARE YOUR BOTTOM! Ender 3 & CR-10

Most of these are winded and long videos as they are about technical adjustments so you have been warned! Not funny or exciting just adjusting stuff

Dude, please. I really like your videos, but the eating sound is horrible. Right now I have watched 2 minutes of the video and am fighting with myself, whether i can continue waching with this sounds :( (I will probably watch it, the content is very good :D )

Another good video.Get the camera thing worked out and you have some really good content.

Just what the doctored ordered as a machinist it was the first defect I noticed. Out of square. So that's why I looked on you tube to see if others had the same issue. Thanks

what are the sizes and type of square/ruller you were using? looked on amazon and could not find one beefy like that.

where do you get those type of shims...? thanks

I don't think the corners are critical. What's important is that the z is square and the y-carriage is perpendicular with the plane of the two z beams.

just like to say thank you for this video it help to sort out my CR-10 & now my is base & uprights square now can upgrade it.

Wanted to watch this so bad, stop crunching candy with a head mounted camera please!!

Thanks for the video. I'm new to 3d printing, and this thing not being squared and true drives me nuts. I'm going to buy another feeler guage and use it to make my shims.