How to Check SMD Resistors Good or Bad

How to know if your arm is ok: 1. Your arm is ok. 2. Your arm is not okay. 3. Your arm is not your arm. So not okay.

Thanks

Are these measurments on board, sorry if that is the case you can not tell if the resistor is ok or faulty, the value measured will be affected by nearby circuitry

換気システム

Third one is ok what the problem?

❤❤❤❤❤❤❤❤❤🇧🇷🇧🇷🇧🇷🇧🇷

Off circuit, what if they are in circuit ?

Wonderful i never knew this

Oui mais en test sur circuit la valeur peut varié en fonction des autres composants qui y sont relié

resistors values are not always exact they all have tolerance levels or margin of error from the factory

Must resistors be tested out of circuit (be removed)

How to tackle circuit influence in reading?

Please please send me more bro

all looks good.. but how does the resistor lose value?

How to check it in the pcb ?

How about i buzer mode?

原点地
ファン
起動

So does the third one mean that a higher voltage (signal) can pass through intermittently?

Capasitor how ?

nice!!!

That is not a stator y can't ANYONE TELL ME ANYTHING

Does it mean that none of them is good?

thanks bro

Tapi sayang saya tidak punya avometer digital karena kalau yang non digital saya kurang paham pembacaannya dan akhirnya menurun dan hilang minat belajar lebih dalam dan lebih kreatif ya mungkin untuk bantu istri atau orang tua saya yang makin menua..😢😢😢❤❤❤👍👍👍

What if the resistor value is 21Kom and it shows 22kom .

❤❤محتوى يستحق الدعم ❤❤❤

He playing guitar 30 hours a day every day

All is nok

Genial me encanta tus videos. Gracias por compartir

Nice 1

best of luck

Thanks for the information this can be very inmportant. for me to learning.❤❤

you forget a 4th measurement. The resistor can be connected to another component and can shows a lower value than 20K.

What happened to 3rd one?
203 = 19.97k ohms = 2.059m ohms..
Its correct or not?

Nice editing real y nice editing ❤

😅

3

Not possible on third one unless somebody sprayed salt water orther conductive elements or fluids over it /carbon powder or wrong value resistor

❤

Y la de 200

Nycc

Hai sir this type all components cheking videos pls

Very useful info, Hope you make a good info like this in the future. 👍✅

Plz measure with high accuracy multimeter like fluke

What if its showing a different value in a circuit?

Is this open circuit and high ohm problem ？

That's because chips resistor are rated in rank no. Like the sample 203 that mean 20k 201 mean 200 like the capacitor

Did not explain the reading values. No knowledge imparted