Voron 2.4 r2 350mm 3d printer printing at 300mm/s

Fail. You cant even accelerate that fast on this print. Also your accel seems to be like anywhere around 4k

Squish ball feet , if it all moves in unison send it

I would have just used cross strapping to help reduce the uneven shaking.

In his defense though guys, these bigger printers really do get a TON of vibration at almost any amount of acceleration. Even though they’re coreXY, on something this big, 3000 accel is something you’d have to use input shaper for to get the ringing to go away. I have a mercury one.1 built off an ender 5+ so I’m speaking from experience here

There is no way this is going over 150 mm/a in this video

Input shaper can add smoothness is you haven’t logged yet

love how everything on the desk and current print is all hexagon

I like your enclosure... gonna do mine, the same way as yours :D

Oh god, i want one

It's kinda slow. But still faster then what we got used to. Obviously not reaching the speeds.

Did you not seal the panels with foam tape?

maximum 100. not even close to 300

Why is 300mm/s a valid measure? Why not flow mm3/sec or printing.?

That is not 300mm/s. Setting 300mm/s in the slicer is not the same as actually going 300. On those short distances it’s not reaching 300.

To stabilize it. Print a bracket that fits between your wall and the 3D Printer. Screw the bracket to the wall stud and Printer to bracket

Price

Door is shaking more than my diabetic grandma after falling into a pile of sugar

It’s cookin

Nice! Which voron kit did you buy?

Very Very Good

I love Vorons, but I will say you're leaving a lot of performance on the table. My Ender 3 prints faster than this lol

Yeah, the door latches should be used both on the top AND the bottom.

Nitrogen floated air table.

It's funny, I'm printing at 260mm/s and 4500 accel on a Cartesian and running marlin

Dude how quiet is this thing!?

Much better 😉👍😀

The acceleration?