Комментарии:
Hi, great video. If you want to connect an hour meter to my lawn tractor, which only starts when it is turned on, what positive wire should I connect to? I have the block with the lights. Thank you
ОтветитьThis was so beyond helpful
ОтветитьThank you so much for this video! Very clear instructions for testing! It's channels like this that keep us DIYers up and running. Thank you again!
ОтветитьThanks for the video...
ОтветитьFits and works as advertised
ОтветитьI took mine apart because the lights weren't working. Man what a headache. Should have marked the pieces with a line when I pulled them out. Loaded with white grease and couldn't tell what Was what until I cleaned it and forgot how it came out. Your video help me figure it by ohming. Thanks
ОтветитьOn the plug side should any of them get continuity when checked against the ground plug?
ОтветитьExcellent Video...Thanks...maybe go just a tad slower next time!
ОтветитьThanks. Great info. I have a eX mark quest with a plastic 5 terminal switch w/o any letters. Would you tell me how to test for connections. Very frustrating. I cannot tell where ground , solenoid, battery etc. are. Thank you
ОтветитьCould you explain would be the symptoms of a bad switch.
ОтветитьVery well explanations, thank you very much.
ОтветитьOn my Snapper RER ignition switch, I have B S M A B which may be same as the metal one you referenced in a prior video like the MTD (last) one you only showed here. What is that link? The A and B is for?
ОтветитьDude.... Wayy too quick lol... If you could just do this at half speed that would be great
ОтветитьDam dude, you go way too fast to follow you. Show what leads you are touching to the camera. Thank you tbo for the info.
ОтветитьA very nice well prepared and clear video. Thanks!
ОтветитьMy A2 + L isn't getting a beep at all on the run position but does on the reverse position. What does that mean?
ОтветитьPROBLEM! I followed your great directions and my key switch tests good. The starter solenoid is new but does not click when I turn to "Start". If I turn the key to "Run", the only way I can start the engine is to jump from the battery to the starter. The engine runs fine until I turn the key to "stop". Then the engine hesitates but won't stop. I need to disconnect the plug wires to stop the engine. I WOULD REALLY APPRECIATE HELP. Thanks!
ОтветитьA great video - really helpfull. Thanks
ОтветитьThanks for the video! what does the A1 port do? 2nd diagram, I have continuity on (start b&a1) but not on (run b&a1) mower cranks and then dies when let off the key, if i wiggle or keep holding the key it will run for a minute and then eventually die..
ОтветитьExcellent video, thank you for sharing!
ОтветитьI'm teaching my boy and you made me look like I know what I'm talking about. Thank you
ОтветитьThanks so much great video
ОтветитьThanks alot fixed mine by watching your video. Its ok for rich people they give it to mower repair man but for people like me we appreciate your help. thankyou again please make more videos, nicely explained,
ОтветитьMy multimeter has no sound. Might you tell me what I can expect from the readout when testing the last Husqvarna switch ? Thank You.
Ответитьwould you tell me the model # of the Klein tester u are using in this video please. Great video.
ОтветитьThank you
Ответить