Toro Timecutter Zero Turn Mower Tracking Adjustment

Thanks for this! My manual only shows that last adjustment for tracking

Hey Jim
My toro 42” my ride time cutter doesn’t have the nuts for adjustment bought brand new in 2021 model 75745. Is it possible they forgot to put it then on

I got a toro MX 5060 that works fine but for abt a hr or less, then the left pump just gets weak, to the point the i can not turn, i turn it off, leave it till it cools off and then its back on again, any ideas on what could be wrong ?

Thanks for your videos. One question please. Just got my 2020 50" Timecutter back from the Toro Dealer and now when I come to a stop and go into neutral to fold out the handle bars it goes into reverse before I can put it in park. Where would I adjust that? Thanks for your information. So basically before I can park it wants to reverse.

My 34 inch mower while parked, tends to roll backwards? Is this part of it or somewhere to adjust the brake? Will brakes after couple inches rolling back at least 5-6 inch.

Does this work on the 2022 titans too?

it’s probably not recommended, but how do you adjust the governor on a toro time cutter?

I just had my 42” Timecutter delivered two weeks ago. I have the third issue you called out on your 42” where the handles aren’t even.

Thanks for posting this.

Thank you for the wonderful break down

Worked great! Thanks Buddy!

What should the tire pressure be set to for the rear and front?

thanks, great video

Does the same adjustments go or a toro titan?

What should be the ideal tire pressure for my front & rear tires on my 50" deck zero turn toro 24.5hp?

Changed the blades on our Timecutter 54", model 75757. Belt stuck under the Idler Pulley and wife smelt rubber. Pulled deck back out, loosened bolt on idler puller and released belt. Replaced everything back properly this time. When turning on the blades we just hear a click and no blades will turn at all. Thanks for any knowledge share as to what to check; stuck in from North Carolina..

Please show tracking on a SW5000

Just received a 75750. I found that if going in reverse and trying to turn the front to the right the right wheel doesn't move very much (although when going straight in reverse it seems fine). If I reverse and turn to the front to the left there's no problem. Put the controls in neutral, pull back on the right one and nothing much happens. Pull back on the left one and the left wheel goes into reverse. A Toro dealer couldn't help me.

How to slow down my time cutter hard ground I have to slow down the problem is can't hold a straight line's holding the handles down half way

My stepdad has an older 74327 mower, I can't find anywhere one it which nuts might correspond with the ones you're showing. Right side doesn't go forward at all!

I have a 2020 75742 time cutter and I don’t have an adjustable nuts and that half moon thing doesn’t work

When I push both handles as far as I can forward it goes in a leftward circle. The right handle pushes the mower a lot faster than the left so ultimately to go straight it goes slower than in a circle. How would you correct that? And is there any way to make the mower go faster? Thanks.

I have a toro ss5000 and it does NOT have those half moon adjusters. I can see where they would be, but nada. NO scratched paint, was never there. Now what?

Doing the adjustment tomorrow. Info exactly what I needed

What about when the right arm is stiff

How about a 2007 z5000. Pulls to right. Doesnt have that style.

My Man….Excellent tracking adjustment presentation!!!! Got it ! Thank you…nicely detailed 😊

The right handle on my time cutter does not respond. Is this what I need to adjust?

I've got a 2025 timecutter max 54...levers are slightly off but mine doesn't have that adjustment???